Why Your Recording Is Distorted, and How to Prevent It
Distortion is one of the most common problems people send me. A wedding officiant who sounds crunchy every time he raises his voice. A speaker at an event who breaks up on every laugh. The voice is loud enough, but it sounds harsh and fuzzy, like a blown speaker.
What distortion is
Every recorder has a ceiling. When the sound coming in is louder than that ceiling, the recorder cuts off the top of the waveform. This is called clipping. The part that gets cut off is gone, and what's left sounds harsh.
Light clipping, a few peaks here and there, can be repaired. The de-clip tools in iZotope RX redraw the missing tops of the waveform, and on short peaks the result is very good. Heavy clipping across whole sentences is harder. Too much of the sound is missing for software to rebuild.
So the best fix happens before you press record.
Set your level for the loudest moment
Most people set the level while someone talks normally. Then the speaker laughs, shouts, or leans in, and the recording clips. Set the level for the loudest moment you expect:
- Ask the speaker to talk as loud as they will during the event. A laugh or a big "thank you, everyone" works.
- Watch the meter. Peaks should land around -12 dB, well below 0.
- Leave it there, even if normal speech looks low on the meter. Quiet speech is easy to bring up later.
Keep the mic a steady distance away
Distortion also comes from a mic that's too close to a loud source. Think of a phone on the pulpit next to the speaker, a camera beside the DJ booth, or a lav clipped right under the chin. Clip a lav about a hand's width below the chin, and keep handheld recorders a few feet away from speakers and PA systems.
Use a 32-bit float recorder
A 32-bit float recorder takes most of the risk out of setting levels. It captures a huge range of loudness in one file, so a recording that comes in too loud can be turned down afterward and stay clean. For events you can't redo, like weddings, speeches and interviews, this is the feature I'd look for first.
As an Amazon Associate I earn from qualifying purchases.
- For the person speaking: the Tascam DR-10L Pro (paid link) is a small 32-bit float recorder with a clip-on lav mic. Put it in the officiant's pocket and clip the mic to their lapel, and you get the vows recorded right at the source.
- For a room or a table: the Zoom H1essential (paid link) is an affordable 32-bit float handheld recorder. Set it on a table or a stand near the people talking.
32-bit float protects the file from a level set too high. A mic pressed right up against a loud PA speaker can still overload, so distance still matters.
Test before it counts
Record a minute, play it back on headphones, and listen to the loudest part. If it sounds harsh, turn the level down or move the mic back. It takes a minute and saves the recording.
If it already happened
Send me the file. If the clipping is light, I can usually smooth it out, and I'll send you a sample of the fix before you pay. If it's heavy, I'll tell you up front.
Common questions
Why does my recording sound distorted?
Distortion usually means the recording level was set too high, so the recorder cut off the loudest parts of the sound. This is called clipping. A mic placed too close to a loud source causes it too.
Can distorted audio be fixed?
Light clipping on a few peaks can usually be repaired with de-clip tools. Heavy clipping across whole sentences has too much missing for software to rebuild, so prevention is the best fix.
What is a 32-bit float recorder?
A recorder that captures a very wide range of loudness in one file. A recording that comes in too loud can be turned down afterward and stay clean, so levels set too high on the day are much less of a risk.
Have a recording that needs help?
Send the file. I'll tell you what can be saved and send a sample of the fix before you pay.
Written by

Trevor O'Hare
Podcast Editor & Producer
I'm Trevor O'Hare. I edit podcasts for a living, backed by more than 20 years in professional audio. If your show needs a steadier sound, or your week needs fewer editing hours, that's what I do. Flat rates start at $100 per episode.
Learning voiceover? I also teach at VOTrainer.com.